click on photos for full size
fuel is dumped into carb in hard corners right here
out the plug on top of the inlet and look down it , you can see
right into fuel bowl and floats. Plug that passage to the float
chamber, and epoxy a fitting to the opening as shown in photo
below.
the photo and epoxy a length of
tubing as shown. Be careful not to go
to far into fuel Bowl you want it to be
above the fuel. Then add a piece of
hose between the two fittings you
install, as shown. Just make sure it is
about 2-3 inches above carb top and
is fuel proof, I used model airplane fuel
line because I had it and it has lasted 3
years now with many laps around PIR
at last years convention.
for this tip. He came through
when I needed it.